With the continuous development of Chinese industry, the technology of cold forming has also been developed rapidly.Cold bending machinery equipment to become a number of professional factories indispensable machinery.So the use of cold bending machinery equipment also need to pay attention to the place.
First of all, choose the flat table, put the machine, you can pull the chassis feet so that the machine face easy to observe.Insert the plug of the hand-held sensor head into the socket on the panel and tighten it, taking care to locate the gap.
Secondly, plug one end of the power cord into the socket on the back board of the chassis, and plug the other end into the power supply socket. Please be sure to use single-phase three-wire power supply.Then open the "POWER SW." on the back board of the case, press the "POWER Switch" key in the panel, and its service will be switched to the "WARM UP" green light.Press and hold the "SETTING BUTTON" BUTTON and set it to an appropriate value, generally between 0.5 and 2.0 seconds.
Put the sensor on the top of the container again and press the start button on the handle, then the red indicator "HEATING" will light up to show that HEATING is taking place. Do not move the sensor while the red indicator "HEATING" will go out.
After the "WARM UP" green indicator lights UP or the short "Beep" of the machine buzzer prompts, the sealing of the next container can be carried out.Check the sealing quality, and properly trim the "SETTING BUTTON" BUTTON according to different materials, diameters and production efficiency, so that the sealing quality is superior.
