Communicate with Supplier? Supplier
Jason Wang Mr. Jason Wang
What can I do for you?
Chat Now Contact Supplier



Home > News > Uncoiler routine maintenance

Uncoiler routine maintenance


To uncoiler life more lasting, we need to carry out routine maintenance it carefully, follow these steps:
1, according to the requirements of each cup oil lubrication and artificial lubrication points refueling.
2, according to the parameters specified Uncoiler uncoiler conduct Coil, Coil thickness of 20mm, the maximum length of 2500mm, coil material is less than the yield limit 250Mpa.
3, after the power is turned on the next roll on roll both directions and down movement, check there are no unusual movements stuck phenomenon.
4, in strict accordance with uncoiler coil processing procedures and operating methods of operation, when the roller lift to the limit position, we must pay great attention to the safe operation of the equipment.
5, when the main drive after shutdown before proceeding to lift the roller bearing dumping reset flip and tilt on a roll.
6, during operation, if found irregularities with irregular noise, impact, etc., should immediately stop checking.
7, the operation of each staff to coordinate with each other, listen to the person in charge of directing coil, there is no password, prohibit start the machine.
8, conducted uncoiler coil operation should pay great attention to the hand being pressed steel plates together and roll into.
9, with the lifting plate or reel while driving, be careful not to collide with the machine.
After unwinding machine work, do work completed, materials to make the site clean and good equipment maintenance work, be turned off.

Send Inquiry

Jason Wang

Mr. Jason Wang



Mobile Phone:+8618868400668Contact me with Whatsapp

Address:No.755, Xintangtou Village, Xinjie Street, Xiaoshan District, Hangzhou, Zhejiang

Mobile Site